Unnathi Groups Technology Reinvented

PU Marking System - FD

Brushable / Rollable / PU Marking System with Fast Drying

Extremely eassy to clean, seamless hard wearing PU floor / path / concrete Road Marking at that produce attractive aesthetic appearence. Ideally suited for areas where high degree of Safety Maintenance required. Exceptional resistance to abrasion and to a wide range of chemicals.

Unnathi Suppliers | +91 9036132477| [email protected]

PU Marking System - FD

Technical Data
Maximum Operating Temperature, °C 121
Mixing Ratio By volume, (R : H) 4:1
Pot life at 30 °C , minutes 20
Full cure at 30 °C , hours 4
Coverage per coat, per ltr, Sq.mtr 4
No. of coats required 2
Film thickness per 2 coats, microns 80-120

Applications

  • Effluent treatment plant
  • Battery room
  • Chemical storage area
  • Chemical processing area
  • Laboratory
  • Sewage treatment plant

Pack Size

  • 20 Ltr.

Surface Preparation :

Surface to be coated must be structurally sound, dry, free from loose material. All surface contamination must be removed. Grease and oil should be grit blasted or water jetted. Deeper penetration must be removed by mechanical means.

Mixing :

Contents of Resin and Hardener should be thoroughly stirred individually to disperse any settlement which may taken place during storage. The entire contents of Hardener should be poured into Resin and the materials thoroughly mixed for at least 3 minutes taking particular care to scrap the sides and bottom of the container. Mechanical mixing using a slow speed (300-400 rpm) electric drill fitted with mixing paddle is preferable. Follow mix ratio for part mixing.

Application :

Apply mixed materials with stiff nylon brush. The 1st coat must be firmly applied and be well scrubbed into the surface. The 1st coating should be allowed to become tack free, before applying the 2nd coat. No thinners or solvents should be added.